3 Axis Stepper, Motor Driver

  • Triple Independent motor driving
  • Sine Wave-like output signal
  • High Accuracy Micro-Stepping
  • Automatic Power Reduction mode
  • Continuous 3 Amp per phase current
  • Enhanced motor performance
  • On board 3 variable speed oscillators
  • End of Travel Switch inputs
  • On board GO/REF/LIMIT LED indicators
  • Remote Status indicators
  • Service Operation mode (stand alone supported)
  • N.O. or N.C. Limit logic


Delivery: Next Day

The PMD-53031 is a low cost, yet sophisticated and independent 3-Axis Stepper Motor Driver. It is a high efficiency 3 Amp Chopper Driver, with an Automatic Power Reduction circuit, that minimizes the power dissipation while idling. The driver has 200/400/800/1600 or 400/4000 (version depended) steps per revolution (ppr) operation modes with Sine Wave-like output signal, providing an accurate resolution. The PMD-53031 has Clock & Direction inputs(CK&DIR), to be controlled by a host computer, a CNC, a remote controller or a PLC. It has GO & DIR inputs for service operation and two "End of Travel" switch inputs, to prevent any Out of Limit move (caused by either a hardware or software error). The driver is aimed at low to medium power systems and can drive 4, 6 and 8 lead stepper motors, of 0.2 to 6 Amp phase current. All driver inputs range from 5 to 35 volts for lab and industrial use. Its power requirement is a single 12 to 24 volt DC source of any kind, regulated or unregulated, with an Output Current of 2 to 10 Amp, depending on the motor type. Enhanced motor performance and higher speed performance can be achieved by connecting a 12-24VDC power source to the logic circuit and a 12-42VDC power source to the motor circuit.